|
Back to Lure
Paints Index | Back to Catalogue Main Index
CLEAR EPOXY
SEALER KIT
SPECIAL
SHIPPING NOTICE: Epoxy Clear Coat Sealer may only be shipped
ground within
Canada.
If your order contains Epoxy Clear Sealer it will automatically be shipped ground. We
can not export Clear Epoxy Sealer.
 |
Our best, super high gloss, epoxy clear
coat for use on wood lures, plastic lures, jigs and more.
- Apply on your wood and plastic body
baits to give them a deep high gloss finish in a single coat that will
withstand chipping and extend the life of your lures.
- Highly recommended and used on all musky and pike
lures.
- You may also apply our
Clear Epoxy Sealer on your painted blades to prevent chipping.
- Apply on jigs to prevent the plastisizer in soft plastics
from reacting with vinyl paints.
- This epoxy
provides a tough, super high gloss clear final coat on all of your lures.
- Each 2 oz. kit will coat between 30 to 40
three inch body baits.
- One coat equals up to 50 coats of
regular clear coat.
|
2 oz. CLEAR
EPOXY KITS
Each 2 oz. kit.
| Item
Code |
Colour |
Size |
Price
per Kit |
| 80-75-02 |
Clear |
2
oz. Kit |
$16.99 |
APPLY ON
- All Your Wooden Lures
- All Your Plastic Body Baits
- All Your Painted Jigs
- All Your Painted Spinner Blades
SPECIAL
FEATURES
- You may add metal
flake glitter while mixing to create special effects.
- You can apply paint over epoxy clear coat to
create amazing layer effects.
- Cures to a hard high gloss finish.
- Remains slightly flexible so that is does not crack
from sudden impact.
- One coat equals up to 50 coats of regular
clear coat.
READ
INSTRUCTIONS CAREFULLY
INSTRUCTIONS: Shake
both Parts A and B lightly before use. In a plastic separate
container, mix "equal parts" (VERY IMPORTANT) of Part A and Part B (1:1).
Stir for at least 5 minutes using a plastic or metal stir stick (do not use a
wooden stick). Pour or brush on lure immediately after mixing. Epoxy will thicken slightly during this
time. An easy method to thin is to pre-heat epoxy by placing the jars in warm
water or heat slightly with hair dryer. Mix only
what will be used within one hour. You may thin with Acetone (available at hardware
stores) but this is usually not recommended. You
may apply by dipping or brushing. Use in a well ventilated area.
Lures should be hung and rotated every 20-30
minutes for approximately 2 - 3 hours in-order to avoid run marks on your
finished lures. Allow to completely cure for 24 to 36 hours (depends on room
temperature and humidity) before use.
DO NOT put mixed Epoxy back
into Part A or Part B containers.
DO NOT mix on paper, cardboard or
wood.
SPECIAL
SHIPPING NOTICE: Epoxy Clear Coat Sealer may only be shipped
within
Canada.
If your order contains Epoxy Clear Sealer it will automatically be shipped ground. We
can not export Clear Epoxy Sealer.
|
Sales: 1-800-203-8427
